1. MySpace - Shred One - 32 - Female - la/brooklyn/sf, California ...
I just wanted to let you know that your sets at the cellar and li po MAKE me dance. Thank you. Kid Sundance
2. Programming ESC
Also make sure you dont over discharge the li-po, make sure the speed control is set to protect it with a motor cut off etc. If its your first lipo, than take care when selecting ...
3. Batteries? Orion, Maxamps, etc. - R/C Tech Forums
I use and prefer the Orion Li-Pos, but know that MaxAmps has released a hard case for there Li-Pos I am going to try some of theirs. If your going to use Li-Po make sure that you ...
4. Max Voltage for Power functions - Eurobricks Forums
This should work except for the fact that there is no protection circuitry for the Li-Po. Make sure not to run it too low on voltage before recharging or it will explode.
5. News
Fall River's many white apes hurry like flying snow haul their children over the branches lap at the moon in the water ---Li-Po Make the universe your companion, always bearing in ...
6. Western Canadian Indoor Chanpionship Series - Page 11 - R/C Tech ...
Stu, I also read somewhere that the Orion/Carbon 3200 wasn't available anymore. ... I have to ask, how would the arrival of Li-Po make weight difficult? _____
7. Are RC Helicopter Remotes interchangeable ? - Yahoo! Answers
If you are going to buy a charger, make sure it charges the type of battery you have. i.e. Make sure it could chare Ni-MH or Ni-CD or Li-Po. Make sure its the same voltage as well.
8. Aircraft-worlds new CD motor?? - Page 9 - RC Groups
I cut out it from A3 size inexpensive($2) polypropylene board. AC CD-ROM motor + 5.5x4.5 APC prop. + 3 cell of 700mAh Li-Po make perfect vertical-up.
9. jazzoLOG - Category: Projects
Fall River's many white apes hurry like flying snow haul their children over the branches lap at the moon in the water ---Li-Po Make the universe your companion, always bearing in ...
10. NEW! QuadCopter platform - QuadPowered - Page 549 - RC Groups
Also check that your ESCs cut off is set to off or Li-Po. Make sure it is also set to the lowest possible voltage if there is an option for li-po.
